LOCATION:   [change]
INSTALLATION | FAQs | ABOUT US | TELL US       
 
 0 Item(s) in your shopping cart
Back to: Home> Installation

 
WHEEL COVER INSTALLATION

INSTALL INSTRUCTIONS: Before installation, remove existing wheel cover or wheel ring and clean wheel surface thoroughly. Place the steel ring over the wheel cover so that the steel ring follows the lines of the cover. This is especially important in the tire valve area. See picture attached. Install the wheel cover in the lower part of the wheel rim and hold it with your knee. Press the two upper clamps with your fingers and at the same time push the wheel cover inside the wheel with your knee. Press the wheel cover into the rim along its circumference.

REMOVAL: Insert your fingers with both hands into the wheel cover holes on the upper side of the rim. Begin pulling back the cover by applying uniform force with both hands.

WARNING: Our universal wheel covers are designed to fit most cars. In the event of too tight or too loose fitment, adjust the steel ring as per pictures by stretching the steel ring. If you are not comfortable with any part of the installation or removal of this wheel cover, seek the help of a licensed mechanic immediately.

DOWNLOAD PDF INSTALLATION INSTRUCTIONS
LIGHTING | LED LIGHT BARS | WHEEL COVERS | STEERING WHEEL COVERS | VINYL WRAP | PLATES | ACCESSORIES

Contact Us | Return Policy | © 2017 Alpena