LOCATION:   [change]
INSTALLATION | FAQs | ABOUT US | TELL US       
 
 0 Item(s) in your shopping cart
Back to: Home> Installation

 
INSTALLATION IDEAS

 

TYPICAL LED INSTALLATION
OR
CLICK TO ENLARGE IMAGE
DOWNLOAD PDF INSTALLATION INSTRUCTIONS
 

Installation Instructions

For 12v use only
For best results temperature during installation should be between 70 to 90 degrees F (21-32 C).

If temperature is below 70F or 21C a hair dryer can be used to warm LED and surface.
Clean surface thoroughly with soap and water.
Begin to peel protective backer off 3M tape. Do not peel all the way off.
Position LED over surface and while pressing the LED firmly in place slowly and carefully peel protective backer off 3M tape.
Attach to 12v fuzed source. If you are not comfortable dealing with electrical circuits please consult a certified automotive mechanic.
 
 

Modification Instructions

LED strip can be cut but ONLY where the scissors are shown.

If temperature is below 70F or 21C a hair dryer can be used to warm up LED and surface.
Cut the LED strip ONLY where the scissors are shown.
Using a utility knife carefully remove the plastic lens from the LED strip where you can see two copper points.
Strip black striped positive wire and black negative wire to expose copper.
Solder the black striped and black wires onto corresponding copper points. Seal the solder points with a dab of silicone to help waterproof the LED strip.
Using a hair dryer shrink the heat shrink tubing onto the solder points.
 
LIGHTING | LED LIGHT BARS | WHEEL COVERS | STEERING WHEEL COVERS | VINYL WRAP | PLATES | ACCESSORIES

Contact Us | Return Policy | © 2017 Alpena